Difference between revisions of "Problems and Solutions/cs"
From Aero Manual
(Created page with "Řešení") |
(Created page with "Model osciluje přes osu křidélek, výškovky či směrovky") |
||
Line 12: | Line 12: | ||
|Přidejte v záložce ''Senzor'' zisk senzoru a/nebo zvyšte zisk gyra ve vysílači. Přidejte exponenciální výchylky ve vysílači. | |Přidejte v záložce ''Senzor'' zisk senzoru a/nebo zvyšte zisk gyra ve vysílači. Přidejte exponenciální výchylky ve vysílači. | ||
|- style="vertical-align:top;" | |- style="vertical-align:top;" | ||
− | |Model | + | |Model osciluje přes osu křidélek, výškovky či směrovky |
|Decrease Sensor gain for the affected axis in the ''Sensor tab'' gradually by 5 until this disappears. Check if the mechanics is smooth. | |Decrease Sensor gain for the affected axis in the ''Sensor tab'' gradually by 5 until this disappears. Check if the mechanics is smooth. | ||
|- style="vertical-align:top;" | |- style="vertical-align:top;" |
Revision as of 09:00, 7 October 2016
Popis problému | Řešení |
Aileron, elevator or rudder drifts after initialization | Check trims and subtrims. Sticks in neutral position must be 0%, see the Diagnostics tab. Increase Stick deadband in the Advanced tab. |
Řízení modelu není precizní | Přidejte v záložce Senzor zisk senzoru a/nebo zvyšte zisk gyra ve vysílači. Přidejte exponenciální výchylky ve vysílači. |
Model osciluje přes osu křidélek, výškovky či směrovky | Decrease Sensor gain for the affected axis in the Sensor tab gradually by 5 until this disappears. Check if the mechanics is smooth. |
Model rotation is too slow/fast | Increase/decrease Dual Rate for rudder in your transmitter. Or increase/decrease Feed forward value in the Advanced tab. |
Servos jitter randomly without external influences | Check the cable connection between the receiver and the unit. |
Aggressive stick movement leads to a bouncing | Decrease Feed forward in the Advanced tab or decrease Sensor gain for the affeced axis in the Sensor tab. |
Stick input response is delayed or steering is disconnected | Increase Feed forward in the Advanced tab. |
Initialization finished notification was changed | Flight log from the previous flight was saved. View the log in the Diagnostic tab and fix reported problem. |
Control elements are jumping in a cycle when initialization is finished | The unit was started with the Rescue mode engaged. Turn off the rescue from your transmitter. |